The independent appliance repair shop across the Northeast
Oven Repair — Book a Visit Today
We repair electric and gas ovens, wall ovens and range ovens from all major brands, as an independent shop, so call us and tell us what yours is doing. The usual failures: a cracked bake element, an igniter that glows but never lights the gas, a control board flashing a code nobody can read. Sagging door hinges let heat leak out the top and everything browns wrong. A drifting thermostat or sensor means 350 is really 290. On a visit we test the element, igniter, sensor and board, check the door seal and hinges, then tell you plainly what failed and what it takes to fix. Tight kitchens and old walk-up wiring are normal for us.
Call (888) 826-9217- A real person answers
- Open 7 days
- Written quote before work starts
Taking calls until 5:00 PM ET


The oven symptoms we hear most
- "Nothing heats, but the lights come on" Failed bake element, open igniter circuit, or a relay on the control board
- "Everything burns on the bottom" Broken broil element, weak fan on a convection model, or a temperature sensor that's drifted
- "It takes forever to reach temperature" Weak igniter not pulling enough amps, or heat escaping past a worn door gasket
- "The door won't shut flush anymore" Sagging hinges, stretched springs, or a warped inner door panel
- "There's an error code and it beeps at me" Control board fault, open sensor circuit, or a stuck door lock motor
Safe things to check first
Worth a look before you call — sometimes it saves you the visit.
- 1Confirm the oven breaker hasn't tripped, and on gas units check that the range valve behind the appliance is still open.
- 2Cancel any timed bake or delay start setting, since a leftover program can block the oven from heating at all.
- 3Hold a hand near the closed door edges while the oven runs and feel for escaping heat, which points to a bad gasket.
- 4Set an oven thermometer on the center rack, run it at 350, and note how far off the reading lands.
How an independent local shop compares
| Elite AR | Big-box repair chains | Handyman listings | |
|---|---|---|---|
| You approve a written quote first | ✓ | ✕ | ✕ |
| A real person answers, 7 days a week | ✓ | ✕ | ✓ |
| Gas and electric, all major brands | ✓ | ✓ | ✕ |
| No manufacturer targets to hit | ✓ | ✕ | ✓ |
| Crews familiar with homes like yours | ✓ | ✕ | ✓ |
What homeowners say after the visit
“The dryer quit on Sunday and by Tuesday afternoon it was tumbling again. The quote he wrote up front matched the invoice exactly.”
Sarah K.Toms River, NJ“Tech found a failed igniter in about twenty minutes and had the part in the van.”
Mike R.Nashua, NH“Second visit ever, same easy process. Washer spins like it did the day we bought it.”
Danielle M.Brooklyn, NYOven Repair — quick answers
Why does my food cook unevenly now?
Uneven results usually trace to one heating element working while the other doesn't, a sensor reading low, or a door that no longer seals. We test each in turn instead of guessing, then replace only the part that's actually off.
My gas oven clicks but never lights. What is that?
That clicking is the igniter trying. A weak igniter can glow without drawing enough current to open the gas valve. It's a common wear part. We measure the draw to confirm before replacing anything.
Is it worth repairing an older oven?
Often yes. Elements, igniters, sensors, hinges and gaskets are standard parts on most ovens. We look at what failed and whether parts are still available for that model, then give you a straight read so you can decide.
Can you work on a built-in wall oven?
Yes. Wall ovens sit in cabinetry and sometimes need to be slid out for board or wiring access. In older homes that means careful work around trim. We plan the pull before we start.
Should I use self-clean before you come?
Skip it. Self-clean runs extreme heat and frequently kills a marginal element, thermal fuse or control board. If the oven is already acting up, wait until it's repaired before running that cycle again.
How long does a typical repair take?
Many jobs finish in one visit when the failed part is a common one carried on the van. Control boards and model-specific parts may need ordering. We tell you which situation you're in before we leave.
How it works
- Step 1
Tell us the symptom
Call us or fill out the form and describe what you hear, smell or see. Brand and rough age help. We ask a few questions first so the tech shows up with the likely parts already on the truck.
- Step 2
We come look
Pick a window that works for you. The tech tests the machine and checks power, water and drainage, then tells you what failed in plain words. No jargon. No guessing out loud at your kitchen table.
- Step 3
Repair or straight answer
Most jobs finish on the same visit. If a part has to be ordered, we tell you what it is and why. And if the unit isn't worth fixing, we say that, then you decide.
- A real person answers
- Open 7 days
- Written quote before work starts
Why homeowners call us
- Old houses don't scare usRowhouse kitchens, narrow cellar stairs, stacked units jammed into closets. We've pulled machines through doorways built long before these appliances existed. We protect floors and trim, and everything goes back where it stood.
- Symptom-first diagnosisA dryer that runs cold and a dryer that trips the breaker are two different problems. We test before we replace. That keeps us from swapping out good parts and handing you a bill for nothing.
- Independent, not a brand agentWe repair all major brands and answer to no manufacturer. So we recommend the fix that makes sense for your machine and your budget, and that includes telling you when replacement is the smarter move.
- All major brands, gas & electricIndependent service on Whirlpool, LG, Samsung, GE, Maytag, Bosch, KitchenAid and the rest.
- Straight answersNot worth fixing? We say that out loud, and often it saves you the visit fee.
Oven Repair
Small faults become big ones on a schedule of their own
Describe the symptoms and we'll book the visit — takes about a minute.
- A real person answers
- Open 7 days
- Written quotes
- All major brands
- Gas & electric
Rather not call? Get a free quote →